ETI NETCOM ADH Assembly Replacement Procedure page 5

6. The mounting hole "footprint" of the
replacement
mounting bracket most likely does not
match the mounting hole footprint of
the original bracket.
original mounting
configuration must be re-used when
installing the new compressor.
units using
bracket (23159) , that original mounting
bracket (or the replacement provided in
the kit) must be used again. In this
case, cut the
the new compressor to its
mounting bracket, remove the two
screws securing the existing
compressor to its mounting bracket,
then attach
compressor to the original mounting
bracket using the two screws and the
slotted mounting holes used on the
original mounting bracket.
7. Connect the air hose to the same
compressor fitting from which the
original hose was removed in step 5.
8. With the new compressor installed on
the mounting
matching mounting
install the mounting bracket with the
new compressor onto the Pem® studs
from which the original compressor
mounting bracket
Secure the mounting bracket using the
nuts and lock washers removed in step
4. If using the original 2-hole mounting
bracket, torque the two nuts to 10 in/lb.
If using the mounting bracket that came
with the new compressor, torque the
four nuts
South Bend, Indiana USA | networketi.com
compressor assembly
Either way, the
bracket hole
the 2-hole mounting
tie wrap securing
the new
bracket with
hole footprint,
was removed.
to 4 in/lb.
9.
Connect the new compressor green
power connector to the same place from
which the original compressor power
connector was removed in step 3, then
tighten the two end screws to secure it in
place.
10.
On
Reinstall the forward top panel using the
hardware removed in step 2.
11.
Restore machine power.
the
5
ADH INSTRUCTION MANUAL | PART NO. 24098 REV B