Page 1
Egg Station Dual Zone Model ESDZ-1200 owner’s manual Manufacturing Numbers: 9300633, 9300653, and 9300656 www.antunes.com P/N 1012008 Rev. F 05/18...
Error Codes ................12 Factory Reset ................. 12 If you experience any problems with the installation or Hi Limit Control ..............12 operation of your unit, contact Antunes Technical Service at Replacement Parts ..............13 +1-877-392-7854 (toll free). Wiring Diagram ................ 16 Notes..................
USB port of this unit. Doing so may cause damage to the unit. IMPORTANT Antunes reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, or replacements for previously purchased equipment.
Unpacking 1. Remove unit and all packing materials from shipping carton. NOTE: If any parts are missing or damaged, con- tact Antunes Customer Service IMMEDIATELY at +1-877-392-7856 (toll free). 2. Remove information packet. 3. Remove all packing materials and protective coverings from the unit.
EGG STATION DUAL ZONE OPERATION Preparing Unit Rear Display Up Arrow Power and Controls Button Button 1. Place Egg Rings into Egg Racks. 2. Vertically place the pins of the Egg Racks into the slots on the Hinge Bracket. 3. Check to see that all Egg Rings are seated flat on the Grill Surface.
EGG STATION DUAL ZONE OPERATION (continued) Egg Cooking Procedure WARNING Be sure to wear HEAT-RESISTANT GLOVES when 1. Ensure that the unit is set on a level surface. removing the Egg Rack while the unit is on. Use 2. Verify that the unit itself is level so that water does extreme care to avoid personal injury.
EGG STATION DUAL ZONE PROGRAMMING Turning cooking surfaces on or off 3. Use the Up and Down arrow buttons to change the Rear setpoint temperature as desired. Press and hold the Program button for 5 seconds until The default is 275° F. Press the Program but- the unit beeps.
EGG STATION DUAL ZONE BEST PRACTICES Troubleshooting for Under Cooked Eggs Troubleshooting Eggs leaking out of Egg Rings 1. Level unit - adjust feet if necessary, as shown on page 5. The unit must be level before use. Before Egg Ring Replacement depends on usage but in gen- using the unit, adjust the legs of the unit as need- eral, Egg Rings should be replaced yearly.
EGG STATION DUAL ZONE MAINTENANCE WARNING CAUTION Turn the power off and allow the unit to cool Chlorides or high levels of pH or phosphates before performing any service or maintenance. in cleaning agents (e.g. bleach, sanitizers, degreasers, or detergents) could cause permanent Daily Cleaning damage to stainless steel and aluminum surfaces.
Do not use an abrasive scrubbing pad to clean Egg Rings. Damaged Egg Ring. Replace Egg Ring. If the troubleshooting steps listed do not solve your problem, contact Antunes Technical Service at +1-877-392-7854 (toll free). P/N 1012008 Rev. F 05/18...
Board temperature sensor Contact Antunes exceeds 158° F. The unit Technical Service The ESDZ-1200 has two Hi Limit resets - one for the front shuts down. at +1-877-392-7854 cooking surface and one for the rear cooking surface. If a Hi...
EGG STATION DUAL ZONE REPLACEMENT PARTS (Order (Order Item 91) Item 91) Do NOT plug any per- sonal or unauthorized USB device into the USB port of this unit. Doing so may cause damage to the unit. See Next Page P/N 1012008 Rev.
Page 14
EGG STATION DUAL ZONE REPLACEMENT PARTS (continued) (Order item 101) P/N 1012008 Rev. F 05/18...
Page 15
USB A-F Pnl Mount/ A-M Shield 306P130* Nut,Hexkeps #06-32 7001243 ESDZ-1200 Top Cover Kit Steel; Zinc Plated 7001244 ESDZ-1200 Top Cover & Egg Rack Kit 1 0200368 Gasket, Nose Piece 7001245 ESDZ-1200 Egg Rack Kit 0200369 Gasket, Nose Piece Lip...
Antunes reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equipment because of factors beyond our control and government regulations. Changes to update equipment do not con- stitute a warranty charge.
Need help?
Do you have a question about the ESDZ-1200 and is the answer not in the manual?
Questions and answers