Safety Information ......3 or operation of this product, contact Models DCH-100, DCH-200, and DCH- Installation ........3 Antunes Technical Service toll free at +1- 300 are primarily for meats and poultry 877-392-7854. Operation ......... 3 products.
Install and locate the equipment if it has a damaged cord or plug, Contact Antunes Technical only for its intended use as or if it is not working properly. Service for adjustment or repair.
Heated Toaster Glass Warnings (DCH Models) Please follow the Safety Instructions below in order to reduce the chance of damaged/broken glass: Warning: Mishandling this product or failure to follow these instructions may result in shattering glass. DO NOT scratch, chip, or nick the glass. DO NOT place any metal objects in contact with the glass (merchandise holders, signs, etc.).
(C)F** VAC., Non – Locking *** Indicates that the plug comes with a Harmonized Cord. (Assembly Only). WHT BLK Model Designation 5–20P, 20 Amp., 120 DCH-100 (C)T** VAC., Non – Locking TYPE OF POWER CORD DCH-120 (Assembly Only). DCH-200 H = HARMONIZED...
Install components in unit. Crumb Tray (some models) Equipment Setup Do NOT use with Water When placing the unit into service, Figure 1. Display Components (DCH-100 Shown) pay attention to the following guidelines: WARNING WARNING y Make sure power to the...
Then, press the Temp Up or Temp Down buttons to raise or lower the operate WITHOUT water. setpoint temperature. Release when the display shows the desired temperature. Figure 2. Filling Water Tray Figure 4. Loading Food (DCH-100 Shown) (DCH-100 shown) P/N 1010772 Rev. I 12/20 ®...
Maintenance Parts Replacement Front Display Graphics/Bulb Replacement Be sure to follow all of the warnings Halogen Bulb Replacement Turn the Rocker Switch (Power On/ and precautions listed in the Important CAUTION Off) to OFF Safety Information section of this manual. Unplug the power cord from the Do not handle halogen bulbs with electrical outlet and allow the unit...
Rear Door Replacement Side Glass Replacement CAUTION Turn the unit OFF, unplug the power DCH-100/120 Models Front glass panel replacement should cord from the electrical outlet, be performed by two people to Turn the Rocker Switch (Power On/ and allow the unit to cool to room prevent damage to the glass.
Display Codes This section describes the different display codes and their meanings. “LO” flashes during the initial warm up period. The unit continues to display this code until the unit reaches the setpoint temperature. When the unit reaches the setpoint temperature, it displays the setpoint temperature.
Troubleshooting WARNING To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equipment should be per- formed by qualified service personnel. The unit should be unplugged when servicing. Problem Possible Cause Corrective Action Power cord is not plugged in. Plug the power cord into the appropriate outlet.
(See Exploded diagram) 0503033 Display Frame Note 0200202 Magnetic Strip Use only genuine Antunes replacement parts in this unit. 5040036 Base Hinge Assy. Use of parts other than those supplied by the manufacturer will void the warranty. 4030305 Heating Element, 120V 1400 Watts...
Replacement Parts DCH-200/220 Parts list (See Exploded diagram) Note Use only genuine Antunes replacement parts in this unit. Use of parts other than those supplied by the manufacturer will void the warranty. Qty. Qty. Qty. Qty. Qty. Item DCH- DCH-...
Page 16
Qty. Qty. Qty. Qty. Qty. Item DCH- DCH- DCH- DCH-220 DCH-220 Part # Description Mfg. # Mfg. # 120V 120V 230V 9500533 9500734 400K123 Blower Motor, 120 Volt (some models) Incl #69 4000194 Blower Motor 0200154 Magnetic Strip 5040027 Base Hinge Assy. 4030324 Heating Element, 120V, 1400 Watts 4030325...
Frame, Display Note Motor, Blower 120V Incl. #71 400K123 Use only genuine Antunes replacement parts in this unit. Use of (Except Mfg. No. 9500554 & 556) parts other than those supplied by the manufacturer will void the 4000194 Blower Motor (Mfg. No. 9500553) warranty.
Agency is not covered under this warranty and is the responsibility of the end user. Antunes reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equipment because of factors beyond our control and government regulations.
Need help?
Do you have a question about the DCH-100 and is the answer not in the manual?
Questions and answers