Troy-Bilt Horse Owner's Manual page 171

PROBLEM
WHAT TO DO & REFERENCE
13.
After Replacing Bolo Tines,
Tine Stud Breaks or Holders Loosen
-Make sure that keys are in the keyways. Without key in
holder, left tine stud will tighten and break. Right holder
will loosen.
14. Cultivating Tines Break
With First Use
-It might be that inside tine holders on left and right side
were put on wrong side. Cutting edge of tine must face,
forward and strike the ground first. Tip follows edge into
ground. See page 143.
.,
169
I
-Equalize tire pressure.
-Even though bolts are tight, tines may rattle and make
noise. This is due to shrinkage of casting of holder. No cor-
rection is necessary. Just make sure that tines don't hit
transmission tube or hood. Sometimes an extra washer un-
der tine clip will quiet it down.
- Check to make sure that block was not installed upside
down or backwards. Indentation on #1133 adjustment
block should be at bottom of block as it is installed.
- Remove hood bracket and check end cap screws to make
sure'there is sealant on threads, If end cap screws were
tight, remove cap (replace gasket) and check main drive
shaft end play-'see page 129. Shim drive shaft. Permatex
threads of screws.
- Replace seal if bad; see page 127,
-Check for loose cover. Make sure screw threads have
Permatex on them. Replace seal if bad; see page 127.
-Give seals timeto lap in.
- Replace worn or damaged seals.
-Check oil level to be sure.it is not overfull, These spots
act as oil relief points. No further action necessary,
-Check to make sure engine oil isn't dripping from air
, cleaner Qr engine base and traveling along yoke to tiller
. transmission.<>MeR.e 'sure oil doesn't come from reverse
spring and plunger and run down front of transmission.
(Look for it in bottom of engine mount, part #1 002.)
... -Check seal in front tiller cap and gasket, part #1124.
• '.?,iiMGheck engine se'al onPowerTake Off (PTO) shaft. .
-NOTE: Oil can't leak from threaded hole at bottom of
transmission with plastic caP in it.' That hole doesn't go
through transm1ssion ·case, It is for mounting of lower part
.
.
of Dozer/Snow Blade attachment bracket. "
1,poorWhJleTilltng,
-Use tire chains or BarTread tires.
, now Blade or Furrower
15. Tines Rattle