To Install Belts - Troy-Bilt Horse Owner's Manual

REMOVING BELTS
INSTALLING BELTS
To install new belts, use a matched set of belts
only, because they deliver all of the engine pow-
er to your tiller. First, start with the shift block
loosened and the reverse disc removed, as des-
cribed in Step 1 of "To Remove Belts."
1. Shift the Forward/Reverse Lever into For-
ward position and move a new belt between the
pulleys. Loop one end of the belt over the lower
pulley. Bring the lower end of the belt toward
the tiller-anywhere past the groove closest to
the engine, as shown in Sketch 7/21-1. Let that
belt lie there, out of your way.
2. Take the second belt and move it over the top
pulley into the groove closest to the engine. Be
careful to keep the belts near the cast-in belt-
gu ides (shown in Sketch 7/21-2). Keep the belts
well inside the motor mount beyond the largest
groove (for the Reverse Disc) of the lower pul-
ley. This will avoid getting the belt jammed be-
tween the two pulleys.
100
I
STEP 5
(Sketch 7/20-5)
5. Bring the bottom of belt B under the lower
pulley and loop upward. Pull the belt out be-
tween the two pulleys. as you did in Step 4.
Now you are ready to install the new set of
matched belts (part #1128). (See step 5 in
Sketch 7/20-5.)
TO INSTALL BELTS
(Sketch 7/21-1 )
(Sketch 7/21-2)
STEP 1
STEP 2