MAINTENANCE
1.48
1.48
EVERY 50 HOURS
Perform routine checks : Refer - DAILY BEFORE USE.
Check cutterhead roller bearing adjustment:
Important: Prevent Damage - It is essential that the cutter-
head roller bearings are kept in good adjustment in order to
ensure maximum working life. If roller end float is allowed
A
to become excessive premature bearing failure will result.
Grip the roller and move from side to side and up and
down. If excessive movement is detected proceed as follows:
3D924S001A
Carefully tighten nuts 'A' at each end of the roller with the
spanner provided, just sufficiently to remove any end float.
Note: The roller should still rotate freely after adjustment.
Overtightening of nuts 'A' could lead to premature bearing
failure.
Check wheel nut torque settings:
Front axle wheel nut torque setting - 54 Nm.
Rear axle wheel nut torque setting - 54 Nm.
995901PM140404A