Kohler COMPOSED K-20257T-B-CP Installation Instructions Manual page 2

5. 对于直流龙头，安装时注意电池的正负极不能
装反，电池盒盖要拧紧，防止电池受潮。
6. 对于交流龙头，安装时务必按照说明书的要求
正确连接导线，龙头安装完毕后才可向电源盒供
电。
7.
对于冷热混水龙头，先将连接热水的角阀关
闭，以免烫伤。
8.
修理面盆时，用黑色电工胶布粘住感应窗口。
9.
维修交流龙头时，必须断开交流电源并关闭
水源。
使用说明
1. 手伸到出水口下方感应范围
内(感应距离随面盆，周围的
情况而自动调节)，水龙头出
水。手离，0.5～1秒，水龙
头自动止水。
2. 冷热混水龙头水温调节：先
关闭热水角阀，再将冷水角阀旋
至冷水最大状态，再缓慢打开热
水角阀，以免烫伤。如冷水水压
大，打开全部热水角阀后，仍无
合适水温，请再缓慢减少冷水出
水量，直至水温使用舒适。
注意：
请勿将龙头安装在台面上，
同时搭配台上盆。
2 2
5. As for DC type faucets, please pay special attention to
insert direction matches battery poles. Tighten the battery
cover completely to prevent its exposure to moisture.
6. For electric connection on AC faucets, carefully follow the
installation instructions provided. Only provide to the electric
power box after the installation is conpleted.
7. For faucet with temperature mixer, please turn off valve
before connecting to hot water to avoid scalding.
8. Cover the sensing window with black tape when repairing
lavatories.
9. Turn off the electrical source and shut down water
supply before servicing faucet.
OPERATING INSTRUCTIONS
1. Place your hands under the faucet within the
sensor range ( the sensor range will auto-adjust
to its surroundings , the faucet should be on.)
The faucet will automatically turn off after 0.5~1
second after moving your hands away from the
sensor. The sensing distance will be adjusted
automatically per the condition of the lavatory
and surrounding environment.
Adjust the water temp for faucet with
2.
temperature mixture: turn off hot water valve
first, and then turn on the water and adjust to full
cold, slowly turn on hot water valve to avoid
scalding. If cold water pressure is high and
unable to gain proper comfortable water temp
even hot water valve is fully open, turn down
cold water capacity slowly until water temp is
comfortable for use.
Note:
please do not install the
faucet on the table and
match the washbasin
1359742-T01-A