Advertisement
6.1 - Checking and switching enabled antenna
External antenna will be detected and enabled automatically after powering the device (if not added to the Z-Wave network), but you can
switch manually between antennas using the following procedure.
01. Press and hold the S1 button
02. Wait 3 seconds
03. LEDs will show adding and antenna status (Table 1) for 3 seconds
04. LEDs will turn off for 3 seconds
05. When LEDs show the selected antenna, release the button:
ZW LED (blue) for internal antenna, T4 LED (green) for external antenna
(Table 2)
06. If you want to switch the antenna, press and release the S1 button
07. If the antenna was switched, the corresponding LED will flash 2 times:
ZW LED (blue) for internal antenna, T4 LED (green) for external antenna
(Table 2)
7
OPERATION
To control the movement use Z-Wave gateway's interface or click the S1 button (works in Step-by-Step mode).
8
RESET
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave gateway and user
configuration will be deleted.
Resetting the device is not the recommended way of removing the device from the Z-Wave network. Use reset procedure only if the primary
controller is missing or inoperable. Certain device removal can be achieved by the procedure of removing described.
01. Press and hold the S1 button
02. Wait 3 seconds
03. LEDs will show adding and antenna status (Table 1) for 3 seconds
04. LEDs will turn off for 3 seconds
05. LEDs will show selected antenna (Table 2) for 3 seconds
06. When both LEDs light up simultaneously, release the button
07. Press and release the S1 button
08. Both LEDs will flash once at the end of the procedure
9
LED SIGNALS
T4 LED (green)
ZW LED (blue)
OFF
ON for 3 seconds
OFF
2 flashes
OFF
4 flashes
ON
ON for 3 seconds
ON
2 flashes
ON
4 flashes
T4 LED (green)
OFF for 3 seconds
ON for 3 seconds
Table 1 - LEDs Z-Wave and antenna status
Z-Wave adding status
Not added
Added (non-secure, S0, S2 Unauthenticated)
Added successful (Security S2 Authenticated)
Not added
Added (non-secure, S0, S2 Unauthenticated)
Added successful (Security S2 Authenticated)
Table 2 - LEDs selected antenna
ZW LED (blue)
ON for 3 seconds
OFF for 3 seconds
T4 ZW
External antenna
Not connected
Not connected
Not connected
Connected
Connected
Connected
Selected antenna
Internal
External
Advertisement
