Advertisement
1
WARNINGS AND GENERAL PRECAUTIONS
• CAUTION! – This manual contains important instructions and warnings for personal safety. Carefully read all parts of this manual. If
in doubt, suspend installation immediately and contact the Nice Technical Assistance.
• CAUTION! – Important instructions: keep this manual in a safe place to enable future product maintenance and disposal pro-
cedures.
• CAUTION! – All installation and connection operations must be performed exclusively by suitably qualified and skilled person-
nel with the unit disconnected from the mains power supply.
• Important! – If the BUS T4 connection is used for the IBT4N interface, the BiDi-ZWave cannot be connected to the control unit.
• This product may only be used indoors or protected from weather conditions by control unit's housing.
• The product's packaging materials must be disposed of in full compliance with local regulations.
• Do not open the device protection housing as it contains non-serviceable electrical circuits.
• Never apply modifications to any part of the device. Operations other than those specified may only cause malfunctions. The manufacturer
declines all liability for damage caused by makeshift modifications to the product.
• Never place the device near to sources of heat and never expose to naked flames. These actions may damage the product and cause
malfunctions.
• This product is not intended for use by people (including children) with reduced physical, sensory or mental capabilities or who lack experi-
ence and knowledge, unless they have been given supervision or instruction concerning the use of the product by a person responsible for
their safety.
• Make sure that children do not play with the product.
• Check the warnings in the instruction manual for the motor that the product is connected to.
• Handle the product with care, being sure not to crush, knock or drop it in order to avoid damage.
2
PRODUCT DESCRIPTION
CAUTION! – Any use other than that specified herein or in environmental conditions other than those stated in this manual is to
be considered improper and is strictly forbidden!
The BiDi-ZWave accessory is a device that – by means of Z-Wave™ communication – allows for controlling the
movement and status of Gate&Door-type Nice automations compatible with the BUS T4 (Opera) protocol.
Before proceeding with the product's installation, make sure to have the following:
• 1 Nice automation control unit of the Gate&Door catalogue equipped with BUS T4 connector
• 1 Z-Wave smart home controller
• If you want to improve the BiDi-ZWave Z-Wave range: 1 antenna compliant with the technical specification (see
chapter 10) – not included.
3
INSTALLATION
01. Disconnect the power supply from the automation's control unit
02. All LEDs on the automation's control unit should be off before continuing
03. If you want to install the external antenna, you can do it now
Caution! Use only antennas and cables compliant with techni-
cal specification (see chapter 10)!
04. If present, remove the plastic pre-cut element from BUS T4 connector
and check that there are no burrs
05. Insert the BiDi-ZWave into the BUS T4 port of the connector unit
Caution! If the BiDi-ZWave is inserted incorrectly, it may per-
manently damage the control unit!
T4 LED
ZW LED
OFF
S1
Advertisement
