PEAKnx Controlpro Installation And Start-Up Instructions Manual page 47

Note:
In normal operating conditions, it is not necessary to switch off the Cont-
rolpro.
7.2 Cleaning the touchscreen
The glass cover and touchscreen must be cleaned regularly to ensure proper ope-
ration� This will prevent residues caused by use (e�g� fingerprints) or dust from
impairing the touch function� Suitable cleaning wipes are available in the PEAKnx
Shop�
■
Removing the glass cover:
-
Use both hands to take the glass cover on both sides�
-
Carefully pull the glass cover away from the panel towards yourself (mag-
netic mount)�
■
Cleaning the touchscreen:
-
Clean the touchscreen with one of the supplied cleaning wipes�
Avoid damage to the glass cover and display!
■
Do not use harsh detergents, acids or organic solvents� Do not let any mois-
ture get into the unit� Do not spray cleaning agents directly onto the surface
of the touchscreen� Do not use any sharp objects for cleaning�
■
Attaching the glass cover:
-
Place the glass cover with the magnetic mounts over the four intakes pro-
vided and lower the glass until it lies flat on all four corners of the touch-
screen�
-
Ensure that the opening for the camera is positioned on the upper screen�
8. Troubleshooting
8.1 Touchscreen stops responding
If the Controlpro no longer reacts to input on the touchscreen (which may
occur in rare cases following Windows updates), try to reboot the panel� If the
problem persists, disconnect the panel from the power supply, as shown in 8.1.2
Disconnecting the panel from the power supply and restart it� If this does not solve
EN Controlpro, Installation and Start-up Instructions
47