Further Information - Schaeffler ProLink CMS User Manual

Hide thumbs Also See for ProLink CMS:

Table of Contents

Further information

Getting started with the Schaeffler SmartWeb software

Once you have connected and started the ProLink condition monitoring system, you can view the measurement

data of the connected inputs via the Schaeffler SmartWeb software on your computer. In addition, you can adapt

the base measurement jobs, inputs and outputs automatically created and assigned to the modules and sensors for

your system.

Proceed as follows:

1. Connect your computer to the processor module

2. Call up the ProLink with the address 192.168.1.100 via the device's own SmartWeb software in a browser:

3. The Status page of the Schaeffler SmartWeb software opens. Basic measurement jobs, inputs and outputs are

automatically created for the ProLink device and its modules and assigned to the modules. The modules are

displayed in ascending alphanumeric order from left to right. During initial commissioning, this means that the

module with the smallest serial number is displayed on the left. You can check your connection to the respective

physical modules via the module identification

modules:

4. In the left-hand pane, click the Live view button.

If you have connected the ProLink device correctly, you can see the signals of the inputs connected to the

vibration module here:

The following basic prerequisites apply for connecting to the computer:

The ProLink device must be on the network or directly connected to your computer via

Ethernet cable.

If no address was assigned to the ProLink device via DHCP, it has the default IP address

192.168.1.100. In this case, the IP address of your computer must be within the

192.168.1.x range.

For more information, please see the section entitled First start-up in the handbook for the

SmartWeb software. Please contact your system administrator if you experience problems

with the network settings.

When the ProLink device is first commissioned, it may take a while after the power supply is

switched on before all automatic configurations are created and visible in the software.

of the ProLink device via the LAN connection.

and then influence the sequence shown by renaming the

Table of Contents