Table of Contents
Advertisement
1. Open the Configuration > Input configurations > ProLink vibration module (Serial number) >
Acceleration sensor 1-4 area.
2. Click the Edit
The twelve-digit number (e.g. F4:3D:80:12:00:00) is the serial number of the vibration module. You can also find
this number on the outside of the module.
3. In the Edit input configuration dialogue, set the Sensor type to IEPE. Adjust the sensor sensitivity as
indicated in the calibration data sheet of the sensor. You may also need to adjust the Min. and Max. bias
voltage. This is used to detect a defective sensor or cable.
The ProLink system is now ready for use. Further details of the possible settings can be found in the Schaeffler
SmartWeb user documentation.
12
button for the corresponding analogue input.
For each analogue input with IEPE acceleration sensor, the sensor type must be adjusted
separately in the Schaeffler SmartWeb software.
Advertisement
Table of Contents
