Table of Contents
Advertisement
4
Installing the ProLink modules
Important details about installing the ProLink device can be found in the following sections.
4.1 Installation details of the ProLink modules
Installation site
Install the ProLink device at the installation site on a grounded mounting rail. When doing so, make sure that all of
the environmental conditions for operation are adhered to, good ventilation is ensured for cooling, and all
components are easily accessible for maintenance purposes.
Installation material
When installing the ProLink device, note the following:
Details about the mounting rail
·
Width: 35 mm
Securing clips
·
To secure the ProLink device to the side of the mounting rail, you need two suitable securing clips. The securing
clips are not included in the scope of delivery.
Cross-head screwdriver or flat-head screwdriver
·
You need cross-head and flat-head screwdrivers in order to join the connections.
Environmental conditions at the installation site
Note the following environmental conditions for the ProLink system:
Observe the technical specifications
·
Avoid the following installation sites:
·
Locations where condensation accumulates due to sudden temperature changes
§
Locations with easily flammable gases
§
Locations with a high level of conductive dust (iron filings, oil mist, mist, salt vapours or organic solvents)
§
Locations with direct sunlight
§
Locations with strong magnetic fields or high voltage fields
§
Locations at which powerful sound waves and shock waves can make their way directly into the ProLink
§
system.
Position
To ensure good ventilation and to make it easier to maintain/service the device, the following minimum distances
should be adhered to:
Distance of the modules to the upper, lower and side wall: 50 mm
·
Distance of the modules to the front wall or the switch cabinet door: 60 mm
·
The ProLink device may be maintained only by persons who are verifiably qualified to do so
·
in accordance with the relevant rules and regulations.
Ensure that the ProLink device is de-energised while work is being carried out.
·
If you are installing the device in a location with constant vibrations, e.g. on a ship, you can
also use spring terminals instead of screw terminals. Further information is available from our
support team.
for ambient temperature and humidity.
7
From an ambient temperature of 50°C, please increase the distance between the individual
modules to ensure good air circulation.
Installing the ProLink modules
13
Advertisement
Table of Contents
