Rockwell Automation Allen-Bradley PowerFlex Series Installation Instructions

Frame d overvoltage clipping board fuse replacement

Hide thumbs Also See for Allen-Bradley PowerFlex Series:

Download this manual

PowerFlex® DC Drive

Frame D Overvoltage Clipping Board Fuse Replacement

Installation Instructions

What This Kit Includes

Tools That You Need

ATTENTION: Only qualified personnel familiar with DC drives

and associated machinery should plan or implement the installation,

start-up and subsequent maintenance of the system. Failure to comply

may result in personal injury and/or equipment damage.

ATTENTION: To avoid an electric shock hazard, ensure that all

power to the drive has been removed before performing the following.

ATTENTION: This drive contains ESD (Electrostatic Discharge)

sensitive parts and assemblies. Static control precautions are required

when installing, testing, servicing or repairing this assembly.

Component damage may result if ESD control procedures are not

followed. If you are not familiar with static control procedures,

reference A-B publication 8000-4.5.2, "Guarding Against

Electrostatic Damage" or any other applicable ESD protection

handbook.

• Fuses 14x51 mm, 10 A, 90V (3)

• Static strap

• Flathead screwdriver

Publication 20P-IN069A-EN-P

Page 1 PowerFlex® DC Drive Frame D Overvoltage Clipping Board Fuse Replacement Installation Instructions ATTENTION: Only qualified personnel familiar with DC drives and associated machinery should plan or implement the installation, start-up and subsequent maintenance of the system. Failure to comply may result in personal injury and/or equipment damage. ATTENTION: To avoid an electric shock hazard, ensure that all power to the drive has been removed before performing the following.
Page 2 What You Need to Do ATTENTION: Remove power before making or breaking cable connections. When you remove or insert a cable connector with power applied, an electrical arc may occur. An electrical arc can cause personal injury or property damage by: •...
Page 3 5. Remove the three fuses at locations F11, F21 and F31. X1UVW1 XUVW 6. Install the new fuses. 7. Close the control panel. See steps page 8. Replace the DPI cable (if present). Publication 20P-IN069A-EN-P...
Page 4 Europe/Middle East/Africa: Rockwell Automation SA/NV, Vorstlaan/Boulevard du Souverain 36, 1170 Brussels, Belgium, Tel: (32) 2 663 0600, Fax: (32) 2 663 0640 Asia Pacific: Rockwell Automation, Level 14, Core F, Cyberport 3, 100 Cyberport Road, Hong Kong, Tel: (852) 2887 4788, Fax: (852) 2508 1846 Publication 20P-IN069A-EN-P - May 2010 Copyright ©...