Safety Labels - SaMASZ PG 150 Operator's Manual

Inspection and repair
Perform any inspection, repair and maintenance works as well as cleaning parts or assemblies
when the drive is switched off and there is no pressure in the hydraulics, having taken the ignition
key off and set the aggregation of tractor and machine in a standstill position (Journal of Laws No.
12/98 item 51.)
Inspect bolts and other fasteners regularly. Do not operate with damaged or worn fasteners.
Do not operate with damaged or worn fasteners. When the rubber guard shows signs of ageing
(e.g. microcracks over the surface), it should be replaced.
Do not perform any repair works underneath the lifted machine's assemblies, unless protected
against free falling (Journal of Laws No. 12/98 item 51.)
Replace damaged or worn (aged 5 years or older) hydraulic hoses and other hydraulic parts as
recommended by the Manufacturer.
Before any operation, check the condition of cutting knives. If blunt, rotate the knife by 1/3 turn (3
sharp cutting edges per a single knife can be achieved), or handle it for a recovery. Damaged or
worn blades must be replaced.
Use only original spare parts ordered at our store or at your dealer.
During operation, maintenance and adjustment, always wear protective gloves, shoes and clothing
without loose elements, belts, etc. Always respect warnings on safety labels attached to the
machine.
When operating the hydraulics, always wear protective eyewear and gloves. Hydraulic oil leaking
under pressure (16 MPa) may penetrate the skin and cause its irritation thereafter. In such case,
visit a doctor immediately.
In the event of a serious failure, please call for technical service, and if an accident (in this case:
road accident) occurs, respect first aid rules and contact responsible authorities.
Storage
Scissor trimmer grinder should be stored under a roof and protected against access of animals and
unauthorised persons who could get injured.
Transport
Both the driver and the carrier are responsible for the machine's safe transport. Any equipment and
parts must be secured for transport.
Using lifting devices grab only stiff elements on the machine such as housing and mounting plate.
In order to lift the machine, use only lifting devices of hoisting capacity bigger than the machine's
weight provided on the data plate.
On the vehicle's trailer, the scissor trimmer should be protected against moving.
NOTE:
The person in charge of the machine's transport shall be responsible for
securing the danger area and performing the work.

2.2. Safety labels

NOTE:
Always follow the safety labels describing risks, and warning signs attached to
the machine.
NOTE:
All warning labels should be clean and legible.
Lost or damaged labels must be replaced.
New labels can be ordered at the Manufacturer.
Operator's manual
- 5 -
SCISSOR TRIMMER
PG-150, PG-200
PG-150L, PG-200L