10. DISMOUNTING AND WITHDRAWAL FROM USE
NOTE:
When mounting and dismounting, please remember about personal
protective equipment and environmental protection means.
10.1. Dismounting
When partial wear of the machine is found, repair it by replacing any worn parts. Thus, clean the
machine from any dirt and chips. Then drain the oil into a tight tank and close connecting nozzles.
Next replace all worn parts and assemble the machine back with new connecting, protective and
sealing parts. Bolts should be tightened with torque corresponding to their resistance classes (see Tab.
5).
Pay particular attention when mounting and dismounting and use drawings provided in the spare
parts catalogue.
Store damaged or worn parts in a restricted area and then deliver them to a scrap yard.
10.2. Withdrawal from use
If the machine cannot be repaired any more, it should be withdrawn from use. Thus, clean
the machine from any dirt and chips. First, drain oil from the hydraulics and dispose of
properly. Then disassemble the whole scissor trimmer and remember to segregate parts
according to the kind of material used and deliver them to a scrap yard.
10.3. Environment
The machine is a fully natural environment-friendly product.
90% of the materials used in the grinder are recyclable.
Materials used for packaging are 100% recyclable.
Worn machine parts and packaging should be disposed of in accordance with local natural
environment protection regulations.
During the whole operation period, pay attention to prevent any oil leak from hydraulics of the
machine, which may cause environmental pollution.
Operator's manual
- 19 -
SCISSOR TRIMMER
PG-150, PG-200
PG-150L, PG-200L