Initial Adjustment; Preparing For Operation; Safe Start Up And Shut Down - SaMASZ PG 150 Operator's Manual

lift up the connected scissor trimmer slightly above the pallet and check all bolt connections
(Tab. 5) and whether there are no apparent damages,
take off the cutting bars cover and next pre-start scissor trimmer in order to check whether
connections and operation are correct.
NOTE:
When connecting and inspecting the scissor trimmer, follow any and all
safety conditions provided herein.

3.5. Initial adjustment

Scissor trimmer is factory adjusted and requires no additional adjustments. If any signs of improper
operation of the machine are found, please contact the Manufacturer's service.

3.6. Preparing for operation

Before operating the machine do the following:
set tilt by means of mounting plate tilt adjustment (poz. G, Fig. 3),
thoroughly examine the machine for operational condition, plays and damages. Pay particular
attention to condition of bolt connections on cutting knives,
remove any guards, locks and safety devices mounted on the aggregation of extension arm and
scissor trimmer,
connect the PTO shaft to the tractor,
having made sure there is no unauthorized personnel around, start machine with no load and reach
the pre-set PTO rpm rate, and then shut down and check for tightness,
if the machine's condition and its idle operation raise no doubts, start operating.

3.7. Safe start up and shut down

Before operating make sure there are no unauthorized personnel or animals within the range of
10 m. Next set the machine in the mean working position and start it afterwards.
Before stopping the machine first stop cutting by driving the scissor trimmer into a space with no
branches or bushes around. Then turn off the machine's drive. After this it is possible to start operation
of the extension arm in order to set the arm-trimmer aggregate to transport position.
Operator's manual
Fig. 6. Markings of hydraulic hoses
- 12 -
SCISSOR TRIMMER
PG-150, PG-200
PG-150L, PG-200L