Display Assembly - HP EliteBook 850 G7 Maintenance And Service Manual

1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
4. Remove the system board (see
Remove the speakers:
Remove the speakers from the computer (1) . For reinstallation, be sure that the rubber grommets are
▲
properly installed in the speakers (2).
Reverse this procedure to install the speakers.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
4. Remove the power connector cable
Remove the display assembly:
1. Disconnect the antenna cables from the WWAN module (1), and then disconnect the display cable (2).
2. Remove the cables from the clip (3).
3. Disconnect the antenna cables from the WLAN module (4) and then disconnect the left display cable (5).
(Preparation for disassembly on page
(Bottom cover on page
Battery on page 41).
System board on page
(Preparation for disassembly on page
(Bottom cover on page
(Power connector cable on page
32).
53).
32).
Battery on page
44).
Component replacement procedures
32).
32).
41).
57