Solid-State Drive - HP EliteBook 850 G7 Maintenance And Service Manual

Solid-state drive

To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-5 Solid-state drive descriptions and part numbers
Description
1 TB, PCIe, TLC
512 GB, PCIe, TLC
512 GB, PCIe, TLC, self-encrypting drive (SED)
512 GB, PCIe, value
512 GB, PCIe + 32 GB Optane memory
256 GB, PCIe, value
256 GB, PCIe + 16 GB Optane memory
128 GB, SATA-3, TLC
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the drive to the computer.
2. Pull the drive away from the socket to remove it (2).
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
40 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
(Preparation for disassembly on page
(Bottom cover on page 32).
32).
Battery on page 41).
Spare part number
L85348-002
L85360-002
L85368-002
L85364-002
L85366-002
L85354-002
L85356-002
L85346-002