Frame Separation; Assembly; Frame Release Lever And Frame Release Lock-Up Pin - Pride Mobility APEX ALUMALITE Owner's Manual

VI . D I S A S S E M B LY AND A S S E M B LY

FRAME SEPARATION

1. With the seat and battery pack removed (see Disassembly Procedures on previous page), lower the tiller and
tighten the tiller adjustment knob. See figure 23.
2. Lift up on the frame release lever, and pivot the rear section backwards, until the frame hooks are no longer
resting on the lower frame tube.
3. Slowly separate the two sections of the Travel Scooter. See figure 33.
Figure 33. Frame Release Lever (Style A) and Frame Release Lock-up Pin (Style B)

ASSEMBLY

NOTE: Before attempting assembly, tilt the rear half of the Travel Scooter slightly back on the anti-tip wheels
as shown in figure 33.
1. Use the frame release lever to lift the front section as you align the frame hooks of the front section with the
lower frame tube of the rear section. See figure 33.
2. Once the frame hooks are over the lower frame tube, lower the front section and pivot the rear section
simultaneously. This will engage the frame lock-up automatically.
3. Raise the tiller and fully tighten the tiller adjustment knob. See figure 23.
4. Reinstall the battery pack.
5. Reinstall the seat and rotate it until it is secured into place.
6. Unlock the tiller by turning the tiller lock knob 90° counterclockwise. See figure 32.
WARNING! After assembly, make absolutely certain the tiller lock knob is in the unlocked
position before riding your Travel Scooter.
Apex Alumalite
IDENTIFICATION KEY
Frame Hook
Lower Frame Tube
23