ITW Simco-Ion IQ Easy Sensor Bar Installation And Operating Instructions Manual page 9

NOTE – SENSITIVE ELECTRONICS: Risk of equipment damage.
Do not install bar with charged materials present. Bar must already be
connected to power supply in presence of charged materials. Avoid sharp
blows to bar. Dropping bar may cause damage to sensor element. Bar should
be mounted on a structure that is free of vibration.
Figure 4: IQ Easy Sensor Bar Positioning for Closed-loop Operation
5. Attach the sensor bar using mounting bracket and hardware supplied. See
Figures 3 and 4.
6. Lock the sensor bar in the mounting brackets by manually tightening the set
screws in the brackets.
7. Connect the M12 connector of the power cable to the sensor bar and route the
power cable to the power supply safely.
IQ Easy Sensor Bar
Figure 3: IQ Easy Sensor Bar Mounting
(minimum 12" downstream of neutralizing bar)
7
5201226 Rev. F