Vision Engraving & Routing Systems 5 Series User Manual page 89

Operation 89
The Warm Up button will warm up the spindle at a low RPM for for 3 minutes. This is recommended
before using the machine in a cold climate if it has not been used recently.
The Stop button can be pressed at any time during the warm up process to stop the spindle.
The Break In button is used to break in a new spindle. Pressing this button will start the manufacturer
recommended break in process. A count down timer will be shown.
NOTE: The spindle will rotate and stop automatically during this process.
The Stop button can be pressed at any time during the break in process to stop the process. If the
process is stopped, it will need to be re-started from the beginning.
Vision Engraving & Routing Systems runs the break in process for the FMX RHO and NSK spindles prior
to initially shipping the machine. However, if a replacement spindle is purchased, the customer will need
to run the break in process on the replacement motor.
© 2019 Vision Engraving Systems