Table of Contents
Advertisement
Operation
87
The Power Off button shuts the Vision Series 5 controller pendant off and closes the Vision Mov spooler
program.
Press Confirm.
NOTE: When the pendant has powered off, press the power switch on the controller to complete the
power down process.
The Goto Limits button moves the spindle to the machines physical origin location which is typically at
the top left corner of the machine when the job is finished running. The machine will re-check the limit
switch location to re-calibrate the spindle to this location.
NOTE: While the machine is re-calibrating, the Goto Limits button will display Faster. Pressing this
button will increase the speed that the spindle is traveling at during the re-homing process.
Pressing the Stop button will stop the machine only after the Goto Limits button has been pressed
during the re-homing process.
© 2019 Vision Engraving Systems
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 5 Series and is the answer not in the manual?