Vision Engraving & Routing Systems 5 Series User Manual page 85

Operation 85
The Park Position sets the exact location where the where the tool should move to at the end of running
a job. Pressing this button toggles between "At Origin", "At Location" and "At Limits".
The default is "At Origin".
A setting of "At Origin" will move the tool to the currently set origin location when the job is finished
running.
A setting of "At Limits" will move the tool to the machines physical set origin location which is typically
at the top left corner of the machine when the job is finished running.
A setting of "At Location" will move the tool to the X position and Y position entered on the Utilities
screen.
The X Position and Y Position allows the location that the tool moves to at the end of the job to be set.
Select the X Position or Y Position button. Enter the X or Y location value using the keypad. Press
Enter when finished.
NOTE: The Park Position option must be set to "At Location" for these values to be used.
© 2019 Vision Engraving Systems