Vision Engraving & Routing Systems 5 Series User Manual page 86

86 Vision Series 5 Controller User Manual
The Units option allows the display units to be changed.
The options are Inches, Feet, Millimeters and Meters. Pushing the button toggles between the options.
Press the Back button when finished.
The Maintenance button shows information about the Vision Series 5 controller and starts a pendant
firmware update when available.
This screen displays the following information:
·
The number of jobs that the machine has started
·
The total amount of time that the machine has been running jobs
·
The total amount of time that the spindle has been running
·
The controller firmware date
·
The pendant firmware date
Pressing the "Check for Update" button will check to see if a pendant update is available and update the
pendant.
Pressing the Change Log button will show the pendant firmware changes only after an update has been
performed.
Select Back when finished.
© 2019 Vision Engraving Systems