Table of Contents
Advertisement
5.3
Operation
Verifications and Tests Prior to Switching On
Verification / Test
Make sure that:
– there are no foreign
objects in a pot
Cleanness control of:
– internal parts of the
appliance
– surfaces of
accessories
– internal parts of the
appliance
The condition inspection
includes:
– fixed safety elements
EN
– appliance body
Inspection of operational
ability of:
– control elements
designed for assuring
safety
– control systems
Make sure that:
– there are no strange
sounds after switching
the appliance on
14 / 22
Procedure
Visual inspection is aimed at verification if there are
no foreign objects in a pot, such as tools, towels etc.,
as well as no products that are not food products.
Remove such objects if found.
Before use, all surfaces of replaced parts must be
subject to visual inspection for the purpose of
verifying their cleanness.
When mould or other contaminants are found, those
parts should be cleaned following the instructions in
Section 6.2. 'Cleaning'.
All fixed covers must fulfil their functions. Perform
visual inspection of given elements to make sure they
are not externally damaged. Without exception, those
elements must be replaced in case of first signs of
wear or damage. Contact the service company.
All elements must fulfil functions they are intended
for. Operate the elements directly, so that they
executed the intended functions.
Elements showing first signs of wear or damage
should be replaced immediately. Contact the service
company.
After confirming any abnormal sounds during
inspection of control elements, indicating e.g. seizure
or mechanical damages, stop the appliance
immediately, disconnect from power supply and
contact the service company.
Installation and operation
Table 1
130115
Advertisement
Table of Contents
