Verifying The Installation; Powering On The Device - H3C WX5540E Installation Manual

Verifying the installation

Before powering on the device, verify that:
• The correct power source is used.
The grounding cable is securely connected.
•
The console cable and power cord are correctly connected.
•
All the interface cables are cabled indoors. If any cable is routed outdoors, verify that the socket
•
strip with a lightning protector for network ports has been properly connected.

Powering on the device

1. Power on the device. The device initializes its memory and runs the BootWare. The following
information appears on the terminal screen:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Press Ctrl+T to start heavy memory test
Booting Normal Extend BootWare....
The Extend BootWare is self-decompressing......Done!
****************************************************************************
*
*
*
****************************************************************************
Copyright (c) 2004-2017 New H3C Technologies Co., Ltd.
Compiled Date
CPU Type
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
BootWare Size
Flash Size
cfa0 Size
CPLD1 Version
CPLD2 Version
PCB Version
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
2. Press Ctrl + B at the prompt within 4 seconds to access the Boot menu. Otherwise, the system enters
the system image file reading and self-compressing process.
H3C WX5540E BootWare, Version 5.09
: Mar 21 2017
: XLP432
: 1400MHz
: DDR3 SDRAM
: 8192MB
: 1333MHz
: 768KB
: 16MB
: 4002MB
: 006
: 004
: Ver.A
28
*
*
*