Recalling The Memories; Memory Offset Tuning - Vertex Standard SPIRIT VXA-710 Operating Manual

Recalling the Memories

Press the key, repeatedly if necessary, until "MR"
(Memory Recall) appears on the display. In the MR
mode, you will see the previously-selected channel
number appearing at the bottom of the "MR" icon on
the LCD.
Rotate the DIAL selector knob to select the desired
memory channel.
You may change the readout structure of the Memory
display between "Frequency Indication" and "Fre-
quency Indication plus Alpha-numeric Label" by
pressing the key followed by the
To exit the Memory mode, press the
times to return to the VFO mode.
Note 1: In either the Memory mode or the "Book" Memory
mode, an easy way to recall memories is to key in the
memory channel number (except memory channel "Lch"
and "Uch"). For example, to recall memory channel #06,
press .
Note 2: In either the Memory mode or the "Book" Memory
mode, you can change memory channels in 10-channel
steps: press the key momentarily, then rotate the DIAL
selector knob. The " " icon will show at the left bottom
of the display when the 10-channel-step tuning mode is
active. Press the key once more to resume normal
channel selection in one-channel steps.
VXA-710 S O
M O
EMORY PERATION

Memory Offset Tuning

Once you have recalled a particular memory channel, you
may easily tune off that channel, as though you were in the
"VFO" mode.
key.
key four
Note: The Memory Offset Tuning feature will not engage
on any memories on which BRS channels are stored.
M
With the VXA-710 in the Memory Recall mode, se-
lect the desired memory channel.
Now press and hold in the
"MR" indicator will be replaced by one which says
"MT" (Memory Tuning).
Rotate the DIAL selector knob, as desired, to tune to a
new frequency. The synthesizer steps selected for VFO
operation on the current band will be the steps used
during Memory Tuning.
If you wish to return to the original memory frequency,
press and hold in the key for 2 seconds. The "MT"
indicator will be replaced by "MR".
If you wish to store a new frequency set during
Memory Tuning, just press and hold in the
for 2 seconds, per normal memory storage procedure.
key for 2 seconds. The
key