Check The Operation Of The Primary Air Shutter; Adjust The Damper As Needed; Tighten The Damper Handle As Needed; How To Adjust The Door Latches - Vermont Castings Defiant 1945 Homeowner's Installation And Operating Manual

Check the Operation of the
Primary Air Shutter
The primary air shutter is at the back of the ash drop
and is visible from the back of the stove. (Fig. 39) The
shutter must open and close freely when you move the
thermostat lever. If it doesn't, remove any obstruction. If
you need assistance, consult your local Vermont Cast-
ings Authorized Dealer.
Do not change the adjustment of the cable in an at-
tempt to gain increased firing. The air shutter controls
how much air can enter the stove, but chimney draft
is the force that pulls air into the stove. If changing the
thermostat handle position does not lead to changes in
the fire's intensity within four or five minutes, it's prob-
ably due to weak chimney draft (in the case of a weak
fire you can't increase) or an air leak in the stove (in the
case of a fire you can't decrease).
IA N T
D E F
ST548
Fig. 39 The primary air shutter must move freely.
ST548

Adjust the Damper as Needed

check air
The tension on the Defiant's damper is adjustable to
shutter
compensate for compression of the gasket that seals
11/00
the damper to the upper fireback. To adjust the damper:
1. Remove the griddle. Loosen the lock nut at the cen-
ter of the damper. (Fig. 40)
2. Turn the pressure screw approximately one half turn
clockwise with an Allen wrench provided with your
stove.
3. Tighten the lock nut. Prevent the pressure screw
from turning as you tighten the nut. Re-test the
damper.
30001693
Fig. 40 Adjust the damper with the Allen wrench.
A handle on the left side of the stove controls the
damper. The handle attaches to the damper rod with a
set screw. Periodically check the set screw and tighten
as necessary.
The Defiant's doors should close securely to prevent
accidental opening and to keep air from leaking into
the stove. On adequately adjusted doors, the handles
should resist slightly as they are turned to the closed
position and the doors themselves should be drawn
slightly toward the stove.
Over time, the gasket around the doors will compress
and the latches may need adjustment.
To adjust the latches, loosen the small lock nut, rotate
the striker screw a half-turn, and re-tighten the small
lock nut. (Fig. 41) Your stove kit includes an Allen
wrench for latch adjustments. Hold the striker screw to
Primary Air Shutter
keep it from turning as you tighten the lock nut. Make
repeated small adjustments until the setting is right.
Fig. 41 Turn the door latch striker screw in or out to tighten or
loosen the screw.
Pressure Ad-
justing Screw
Allen
Wrench

Tighten the Damper Handle as Needed

How to Adjust the Door Latches

ST554
Damper adjustment
11/00
Pawl
Small Lock-
ing Nut
Large
Locking
Nut
Set Screw
Handle Stub
Defiant Woodburning Stove
Lock Nut
Damper
ST554
Striker Screw
ST531
ST531
Door Pawl
11/00
29