Table of Contents
Advertisement
INSTALLATION
A. To Remove Existing Toilet
Turn off the water supply. Flush the toilet, and use a sponge
to remove the remaining water from the tank and bowl.
Disconnect the supply shut-off valve (if present), and remove
the old tank and bowl.
Remove old gasket from the floor and
closet flange with a putty knife.
Remove old T-bolts and discard them.
NOTICE:
if a new toilet is not installed
immediately, temporarily stuff a rag in
the closet flange.
B. Roughing-In
DANGER: Risk of electric shock.
before servicing.
NOTE:
This product is designed to work with wall mounted
electrical and water supplies. It is shown in the roughing-in.
WARNING: Risk of electric shock.
circuits protected by Ground-Fault Circuit-Interrupters
(GFCI s) or Earth-Leakage Circuit-Breakers (ELCB s).
'
Keep bath and shower away from electrical parts
(such as remote controller, receptacle, audio input
apparatus and so on).
When the electrical supply is mounted on the wall, a GFCI or
ELCB protected and water proof receptacle is required.
Follow the dimensional information exactly when installing a
hardwire electrical supply.
Floor Flange
1144585-T01-A
Disconnect power
Connect only to
Supply Stop (with filter)
(
)
T-Bolts
T
A.
Closet Flange
Fig.#7
7
B.
(GFCI)
'
(ELCB)
The wall location of the electrical and
water supply are interchangeable.
GFCI-Protected 16A Receptacle(water proof)
305mm
Fig.#8
8
-6-
(
)
(ELCB)
(
)
16
150mm
T
(GFCI)
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
