Install The Vitreous Shell; Connect The Wiring Flexible Hose Of Bidet Seat To Tee Connector - Kohler K-4026T Installation Instructions Manual

L. Install the Vitreous Shell
WARNING: Risk of personal
injury. The vitreous shell
weighs 35 kg. Use proper lifting
technique when handling the
vitreous shell.
CAUTION: Risk of product
damage. Do not set the shell
down hard. Gently lift and move
the shell if it is not placed
correctly. If handled harshly,
the shell may chip or break.
Carefully pick up the vitreous shell and
place it over the tank.
Make sure the trapway seats fully in
the outlet gasket. If the vitreous shell
does not sit evenly on the floor, the
trapway is not properly seated.
Make all adjustments gently until the
trapway is properly seated.
M. Connect the Wiring flexible hose of
bidet seat to Tee Connector
WARNING: Risk of personal injury. Make sure the
plug (if plug-in connection is used) and receptacle are
dry. If any moisture is present, allow the area to dry
before plugging the unit in.
If plug-in connection is desired, plug the pump in.
Connect the refill tube.
Connect the wiring harness.
Connect the level switch.
Plug the bidet seat in.
1144585-T01-A
Vitreous
Tank
Fig.#17
17
M.
Level Switch
Refill Tube
Wiring Harness (Bidet Seat)
(
Fig.#18
18
-11-
L.
Collar
)
Wiring Harness (Pump)
( )
)
35
(
Flexible Hose of Bidet Seat
Tee Connector
T