Installation Of Remote Controller Holder - Kohler K-4026T Installation Instructions Manual

INSTALLATION OF REMOTE CONTROLLER HOLDER

INSTALLATION OF REMOTE CONTROLLER HOLDER
NOTE: If the wall for installation is made of special material
(such as wood board, density board and etc.), suitable fixing
methods shall be adopted.
NOTE: The place to install the remote controller shall not be
easily splashed by water.
Choose a mounting location for the remote holder that is
easily accessible while sitting on the seat.
Drilling two holes with depth larger than 45mm on the wall by
drill with a diameter of 6mm in accordance with the position of
screw holes on the remote control holder. Installing the
expansion tube into the holes.
Placing the installation holder on the fixing hole.
Peeling off the release paper of double-sided tape at the back
of holder.
Fixing the holder with screws and install it.
Installing the screw covers on the screws.
Placing the remote controller on the holder.
Installation Steps:
1144585-T01-A
45mm
m
6 m
Remote Controller
45mm
Fig.#22
22
Remote Holder
Expansion Tube
Screw Cover
Fig.#23
23
-13-
6mm
Double-Sided Tape
Expansion Screw