Install Gasket And Collar - Kohler K-4026T Installation Instructions Manual

J.
Remove cap on Tee Connector of flexible hose.
K. Install Gasket and Collar
Place the wiring harness plug, level switch wire, and refill
tube on the floor so they extend out the rear access opening.
Tape them to the floor so they will not be pinched or
damaged.
Fix the gasket to the tank and press tight.
Install the collar onto the tank.
Clip the spray shield into place over the fill valve.
Level Switch Wire
Wiring Harness Plug
(Connected to Pump)
(
1144585-T01-A
Wiring Harness Plug
(Connected to Bidet Seat)
( )
Tape
Electrical Plug
)
J.
Fig.#15
15
K.
Tank
Inlet Tube
Refill Tube
Fig.#16
16
-10-
Refill Tube
Gasket
Collar
Spray Shield
Tank