Connecting A Console Cable - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Unified Security Gateway
Hardware Guide
Procedure
Step 1 Loosen and remove the screw of the ground terminal on the USG rear panel.
Step 2 Align the M4 end of the PGND cable with the screw hole of the ground terminal and tighten
the screw.
Step 3 Connect the M6 end of the PGND cable to the ground terminal of the cabinet, workbench, or
wall.
Figure 2-10 Connecting a PGND cable
----End
Follow-up Procedure
Verify the following after the cabling is complete:



2.2.3 Connecting a Console Cable

After connecting a PC to the console port of a USG6310/6320 with a console cable, you can
use the terminal emulation program on the PC to access the command configuration interface
of the USG6310/6320.
Context
Before connecting a console cable, perform the following operations:

Issue 03 (2015-01-26)
The PGND cable is securely connected to the ground terminal.
The electrical resistance between the ground terminal and ground point is less than 5
ohm on a multimeter.
Check preparations.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Hardware Installation
170