Power Supply System - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Unified Security Gateway
Hardware Guide
Name
MODE indicator (green)
ALM indicator (red)
SYS indicator (green)
Table 1-47
Table 1-47 SPUA specifications
Item
Silkscreen
Dimensions (H x W x D)
Weight
Power

1.3.3.4 Power Supply System

The USG6670 has two 350 W AC or DC power modules for 1+1 power redundancy.
350 W AC Power Module
The 350 W AC power module converts AC power to DC power for the device.
illustrates the appearance of the AC power module.
Issue 03 (2015-01-26)
Description
NOTE
If a hard disk is installed on the device, you must run the disk offline
command in system view and wait for approximately 30 seconds until
the system displays that the hard disk has stopped working before
pressing the RST button. Otherwise, the data may be lost or the hard
disk be damaged.
 Steady on: Hot standby is not configured, or hot standby is
configured but the device is the standby device in an
active/standby mode or the hot standby mode is load
balancing.
 Off: Hot standby is configured in active/standby mode and
the device is the standby device.

Steady on: The system is faulty. For example, the power-on
self test (POST), power voltage, or temperature is
abnormal.

Off: The system is running normally.

On: The system is powering on or restarting.

Blinks every two seconds (0.5 Hz): The system is running
normally.

Blinks twice every second (2 Hz): The system is starting.

Blinks eight times every second (8 Hz): The system
software or configuration file is being upgraded.

Off: The system is faulty.
describes the SPUA specifications.
Description
SPUA
40.14 mm x 402.80 mm × 270.00 mm
1 kg
109 W
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Hardware Overview
Figure 1-55
115