Setting The Lldp Operating Mode; Setting The Lldp Reinitialization Delay; Enabling Lldp Polling - H3C S12500X-AF Series Configuration Manual

Setting the LLDP operating mode

Step
Enter system view.
1.
Enter Layer 2/Layer 3
2.
Ethernet interface view,
management
interface
2/Layer
interface
physical interface view.
Set the LLDP operating
3.
mode.

Setting the LLDP reinitialization delay

When the LLDP operating mode changes on a port, the port initializes the protocol state machines
after an LLDP reinitialization delay. By adjusting the delay, you can avoid frequent initializations
caused by frequent changes to the LLDP operating mode on a port.
To set the LLDP reinitialization delay for ports:
Step
Enter system view.
1.
Set the LLDP reinitialization
2.
delay.

Enabling LLDP polling

With LLDP polling enabled, a device periodically searches for local configuration changes. When the
device detects a configuration change, it sends LLDP frames to inform neighboring devices of the
change.
To enable LLDP polling:
Command
system-view
Ethernet
interface
view, Layer
interface-number
3 aggregate
view, or IRF
•
In Layer 2/Layer 3 Ethernet
interface view or management
Ethernet
lldp [ agent { nearest-customer
|
admin-status { disable | rx | tx |
txrx }
•
In Layer 2/Layer 3 aggregate
interface
lldp agent { nearest-customer |
nearest-nontpmr
admin-status { disable | rx | tx |
txrx }
•
In IRF physical interface view:
lldp admin-status { disable | rx |
tx | txrx }
Command
system-view
lldp timer reinit-delay delay
interface-type
interface view:
}
nearest-nontpmr
view:
171
Remarks
N/A
N/A
By default:
•
The nearest bridge agent
operates in txrx mode.
•
The nearest
bridge agent and nearest
non-TPMR bridge agent
]
operate in disable mode.
In Ethernet interface view, if you
do not specify an agent type, the
command sets the operating
mode for nearest bridge agents.
} In aggregate interface view, you
can set the operating mode only
for nearest customer bridge
agents and nearest non-TPMR
bridge agents.
In IRF physical interface view,
you can set the operating mode
only for nearest bridge agents.
Remarks
N/A
The default setting is 2 seconds.
customer