Service And Maintenance; Transport - Festool CARVEX PSC 400 EB Instruction Manual

X
Slide all four latches upward [15-2].
X
Snap all four latches back to their flat position
[15-3] so they engage the stacking tabs of the
upper systainer.
WARNING
Any maintenance or repair work that requires
opening of the motor or gear housing should only
be carried out by an authorised Customer Service
Centre (name supplied by your dealer)!
X
Maintenance or repair work carried out by an
unauthorised person can lead to the wrong con-
nection of the power leads or other components,
which in turn can lead to accidents with serious
consequences.
WARNING
Risk of injury, electric shock
X
Always disconnect the battery pack from the
machine before any maintenance or care work!
Do not open the battery pack or the charger. Even
after disconnection from the mains, there is still a
high capacitor voltage inside the charger.
Damaged safety devices and components must be
repaired or replaced in a recognised specialist
workshop, unless otherwise indicated in the oper-
ating manual.
Observe the following instructions:
– Keep the air slits on the machine and the charger
free and clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
– Check the guidance roller regularly for wear.
– Regularly remove dust deposits from the chip
guard.
– Regularly clean the base runner to prevent
scratches and cores on the surface.
The equivalent amount of lithium in the LiIon bat-
tery pack is less than the applicable limit value and
certified as per UN manual ST/SG/ AC.10/11/rev. 3
part III, subsection 38.3. The LiIon battery pack is

Service and maintenance

– Do not open the battery pack or the charger. Even
after disconnection from the mains, there is still
a high capacitor voltage inside the charger.
– Make sure that metal objects (such as metal
chips) do not collect in the battery pack retaining
slots or enter the machine through the air vent
slits (danger of short circuit).
– Do not charge battery packs from external man-
ufacturers. The charger is designed for charging
original battery packs only. Otherwise there is a
danger of fire and explosion.
Information on battery packs
– Where possible, store the battery pack in a cool, dry
place at a temperature between 5 °C and 25 °C.
– Battery packs are most efficient at temperatures
between 20 °C and 30 °C.
– Protect the battery pack from moisture, water and
heat.
– Significantly shorter operating times after each
charge indicate that the battery pack is worn and
should be replaced with a new one.
– The LiIon battery pack is fully compatible with the
charger! Integrated electronics prevent overload-
ing and overheating during the charging process.
– Do not leave flat battery packs in a charger discon-
nected from the mains power supply for longer
than one month. There is a risk of total discharge
and the maximum power of the battery pack may
decrease.
– Store the battery pack in its packaging to reduce
the risk of short circuits..
– If LiIon battery packs are to be stored for long pe-
riods without use, they should be charged to 40 %
capacity (approx. 15 mins. charging period).

Transport

therefore not subject to national and international
dangerous goods regulations, neither as an individ-
ual component nor as a fitted machine component.
However, dangerous goods regulations may apply
17