Festool CARVEX PSC 400 EB Instruction Manual page 16

X
Mount the adaptation table [12-1] on the saw
table support.
X
Close the change lever [1-8].
Ensure that the adaptation table is firmly seated in
the guide.
L Use the extractor connector [1-7] also with the
adaptation table.
12
Adaptation to the guide rail FS
The use of the Festool guide system FS (Picture
[13]) makes it easier to produce straight and pre-
cise cuts, in particular, with material thicknesses
up to 20 mm (0.79'').
13
X
Mount the jigsaw with installed adaptation table
[12-1] on the guide rail.
16
Adaptation to the circle cutter
14
14-1
The circle cutter can be used to create circular cuts
with a diameter between 120 and 3000 mm (4.7'' -
118.1''). The circle cutter can be installed from both
12-1
sides on the adaptation table.
X
Mount the jigsaw with adaptation table on the
adapter [14-1] at the circle cutter.
X
Insert the centring mandrel [14-2] in the bore
[14-4] of the circle cutter, which is aligned with
the saw blade.
X
Clamp the measuring tape at the circle cutter
with the rotary knob [14-5].
L Store the centring mandrel in the depot [14-3].
Systainer
Many Festool products are shipped in a unique sys-
tem container, called "Systainer". This provides
protection and storage for the tool and accessories.
The Systainers are stackable and can be inter-
locked together. They also can be interlocked atop
Festool CT dust extractors.
X
Place one systainer on top of the other.
X
Release all four latches on the lower systainer
by pulling back at their top edges [15-1].
14-5 14-4
Systainer
15-1
14-2
14-3
15-3
15-2