Accessories - Festool CARVEX PSC 400 EB Instruction Manual

WARNING
Looking into the light source can damage your vi-
sion.
X
Do not look into the stroboscope light.
A continuous light or stroboscope is installed for il-
luminating the cutting line:
up to approx. 2100 rpm: continuous light
from approx. 2100 rpm: stroboscope light
L In overhead position (+/- 45°), the lighting is
switched off completely.
Metal processing
When processing metal, the following mea-
sures must be taken for safety reasons:
– Connect the machine to a suitable dust extractor.
– Regularly remove dust deposits in the motor
housing.
– Use a metal saw blade.
– Close the chip guard.
Use only original Festool accessories and Festool
consumable material intended for this machine be-
cause these components are designed specifically
for the machine. Using accessories and consum-
able material from other suppliers will most likely
affect the quality of your working results and limit
any warranty claims. Machine wear or your own
personal workload may increase depending on the
application. Protect yourself and your machine, and
preserve your warranty claims by always using
original Festool accessories and Festool consum-
able material!
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festoolusa.com".
Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all applica-
tions that are specially designed for your Festool
jigsaw.
Sawing with special base runners
The special base runners protect high-quality sur-
faces against scratches and scores.
X
Press in the base runner at position [7-1].
14
Wear protective goggles.
Acoustic warning signal
Acoustic warning signals sound and the machine
switches off in the following operating states:
peep ― ―
– Battery flat or machine overloaded.
X
Change the battery.
X
Place the machine under reduced stress.
peep peep ―
– Machine is overheating.
X
You must allow the machine to cool before using
again.
peep peep peep
– LiIon battery pack is faulty or has overheated.
X
Once the battery pack has cooled, perform a
functional check using the charger.

Accessories

X
At the same time, push the base runner for-
wards.
X
Mount another base runner and push it to the
rear until it engages.
7
Sawing with the angle table
Risk of injury
X
Always disconnect the battery pack before in-
stalling the angle table!
WARNING
7-1