Festool CARVEX PSC 400 EB Instruction Manual page 12

4
with new splinterguard
L When it is worn, push the splinterguard approx.
3 mm further to the rear and continue using it.
L To guarantee reliable operation of the splinter-
guard, it must seal tightly on both sides of the
saw blade. For splinter-free cuts, therefore, a
new splinterguard should also be used after ev-
ery saw blade change.
Dust extraction
WARNING
Dust hazard
X
Dust can be hazardous to health. Always work
with a dust extractor.
X
Always read applicable national regulations be-
fore extracting hazardous dust.
12
4-2
4-1
with worn splinterguard
approx. 3 mm(0.12'')
5
The extraction adapter [5-3] allows jigsaws to be
connected to a dust extractor (hose diameter 27
mm).
X
Insert the extraction adapter into the rear open-
ing of the saw table so that the hook [5-2] en-
gages in the [5-1] recess.
X
To remove the extraction adapter, press the
hook [5-2].
Changing tools
CAUTION
Hot and sharp tools
Risk of injury
X
Wear protective gloves!
Deformed or cracked saw blades and saw
blades with blunt or broken cutting edges
must not be used.
Selecting saw blade
Only use saw blades with a T-shank. The
saw blade should not be longer than that re-
quired for the intended cut. To ensure safe
guidance, during the cut the saw blade should
emerge at the bottom of the workpiece at every
point.
L Only use cross-set saw blades when using the
angle and adapter table. We recommend Fes-
tool saw blade S 105/4 FSG.
5-2 5-3
5-1