General Venting - Vermont Castings Chateau DVT44 Installation Instructions And Homeowner's Manual

Chateau™
Pilot
DC Motor
AF-4000
Main
Black
Red
FP1795
Fig. 11 DVT38/44 wiring diagram.
Your fireplace is approved to be vented either through
the side wall, or vertical through the roof.
•
Only CFM Corporation venting components spe-
cifically approved and labelled for this fireplace
may be used.
•
Venting terminals shall not be recessed into a wall or
siding.
•
Horizontal venting must be installed on a level plane
without an inclining or declining slope.
10
White or Green
Green or White
White or Orange
Orange or White
Power
Orange
Red
Module
Brown
Black
Pulse/Continuous
Button
AC Adaptor
FP1795
Chateau wiring diagram

General Venting

3/07
Main
Module
Learn
Button
Brown
Brown
Red
Black
There must not be any obstruction such as bushes, gar-
den sheds, fences, decks or utility buildings within 24"
(610 mm) from the front of the termination hood.
Do not locate termination hood where excessive snow
or ice build up may occur. Be sure to check vent termi-
nation area after snow falls, and clear to prevent ac-
cidental blockage of venting system. When using snow
blowers, make sure snow is not directed towards vent
termination area.
Location of Vent Termination
It is imperative the vent termination be located observ-
ing the minimum clearances as shown on following
page.
To Pilot Ignitor
To Pilot
Flame Sensor
Optional Remote
Battery Back-Up Pack
Remote/Off
Switch
Continuous
Pilot ON/OFF
Switch
Extension
Wire Harness
Black
Gnd
(SWI) (Leave
Disconnected)
(SWI)
Optional Extension Harness
20011956