If Your Carry On Does Not Operate - Golden Technologies Buzzaround Carry On GB120 Owner's Manual

IF YOUR Carry On DOES NOT OPERATE

• Make certain the freewheel switch is set to the engaged position. See page 19.
• Make certain that the key switch is set to the "On" position.
If the above procedures do not solve the problem, contact your authorized Golden
Technologies, Inc. provider.
WARNING! Do not attempt electrical repairs. Consult Golden Technologies, Inc.
or your authorized Golden Technologies, Inc. provider.
Possible causes for the power module to overload:
• Driving up a long, steep hill.
• Driving over a curb.
• Run-down battery pack.
• Exceeding the maximum weight capacity of the scooter.
As you operate your Carry On, battery voltages go down and battery current must rise
to satisfy the demands of the motor and of other electrical devices operating on your
scooter. This can cause a heavy current draw that can overload the scooter's power
module.
Remedy:
• Do not perform the above "Possible causes for the power module to overload".
• Recharge your Carry On's battery pack. See "Battery Pack and Charging" in this section
of this manual.
• If the problem continues, have your authorized Golden Technologies, Inc. provider load
test the battery pack.
• If the battery pack is good, the charger may be the problem. Consult your authorized
Golden Technologies, Inc. provider.
Restarting the Scooter
If as a result of a run-down battery pack or because of a temporary overload, the scooter
must be restarted:
1. Make certain that the key switch is set to the "Off" position.
2. Wait ten minutes or so for the motor control board to return to the normal operating
temperature range.
3. Turn the key 90 degrees clockwise to turn on your scooter's power. The LEDs on the
battery meter will light up indicating that power is on. See figure 11 on page 20.
If the above procedures do not solve the problem, contact your authorized
Golden Technologies, Inc. provider.
X. CARE AND MAINTENANCE
31