Curtis G3 User Manual page 19

PROGRAMMING GUIDE
Cold Brew Lock - adjusts the temperature at which the brewer will brew when a BREW button is pressed
(Ready to brew appears on the display). This feature also adjusts the temperature at which the heating
below the temperature setting. Once accessed ( ), press
save. Press to display the subsequent menu features.
Master Reset - resets the brewer universal control module (UCM) to the factory default settings. Once
accessed ( ), "Are You Sure?" will appear on the display. Press
display goes back to the programming menu. If you press Yes, the UCM will reset and exit programming
mode.
IMPORTANT: If you reset the UCM to the factory defaults, you MUST reprogram the Model Select to
match the number on the model number label and the label on the UCM for proper operation.
Service Call - sets the service phone number that appears on the display when the UCM detects a SENSOR
ERROR or WATER ERROR. Once accessed ( ), press
to change the number value. Press
repeatedly
Access Code - sets the access code entered to access programming mode (the factory default is 1-2-3-4).
Once accessed ( ), press
number value. Press
display and press . Press
Banner Name - changes the banner name that appears on the display. No banner name appears when all
blanks are entered. Once accessed ( ), press
change the letter. When done, press
subsequent menu features.
P-Maintenance - adjusts the P-Maintenance (preventive maintenance) brew monitor. When on, the UCM
measures the number of gallons brewed before the P-Maintenance reminder appears on the display. The
range is Off to 3000 gallons. Once accessed ( ), press
save. Press to display the subsequent menu features.
Beeper On/Off - turns the beeper that is heard each time a button is pressed. Once accessed ( ), press
to toggle between On and Off. Press
Quality Timer -
the BREW button was last pressed. When time expires, an audio alarm turns on and Quality Timer
the display. Once accessed ( ), press
10 hours. Press to save. Press
Displ. Brew Time - turns the display of the brew time during brewing On and Off. Once accessed ( ), press
or to toggle between On and Off. Press
Display Messages - turns display of the message "Rinse Server Before Brewing" On or Off. Once accessed
( ), press or to toggle between On and Off. Press
features.
Model Select - changes the UCM to operate according to the model number. For proper operation, the model
selected must match the model number label on the outside of the machine. Once accessed ( ), press
until the model number matching the model number label on the brewer appears, then press
will reset and exit programming mode.
or
. Press
or to select the number to be changed. Press
or to select the next number to change. When done, press
to display the subsequent menu features.
to save. Press
or to increase or decrease the amount of time. The range is Off to
to display the subsequent menu features.
to save. Press
or to select the desired setting. Press
for Yes or
or to select the number to be changed. Press
to select the next number to change. When done, press
to display the subsequent menu features.
or to select the letter to change. Press
or to select the desired setting, then press
to display the subsequent menu features.
to display the subsequent menu features.
to save. Press
for No. If you press No, the
to change the
repeatedly
repeatedly to
. Press to display the
to display the subsequent menu
The UCM
.
PG4
to
to
or
or