Front Suspension Oil; Bolts, Nuts And Fasteners; Petrol Tube - RIEJU MR 300 Owner's Manual

Maintenance

31. FRONT SUSPENSION OIL

Adjusting the oil volume
To adjust the oil volume you must first remove
the spring, follow the steps described in
"Change of fork spring". Provide a graduated
cylinder for liquids in which you must enter the
indicated volume of recommended oil (in each
bottle).
Slowly insert the oil from the graduated cylinder
into the fork tube.
And to ensure the correct bleeding of the
hydraulic push the rod gently and alternatively
throughout its entire length (up and down),
several times, until its stops.
Reassemble the fork cap assembly.
Scrupulously respect the fill volume, since on
this depends the level of oil in the inside of the
fork and its correct operation.
Recommended oil KYB 48: KYB 01M Oil for
closed cartridge suspension.
Oil volume: 350 ml.

32. BOLTS, NUTS AND FASTENERS

Every day before using the bike, you should
check that all nuts and bolts are tightened. Also
check that the other fasteners are in place and
in good condition.

33. PETROL TUBE

1
If you observe a pinch (narrowing) in the pipe
(1) in any location (usually in the petrol inlet to
the carburettor and at the outlet of the petrol
cock), or symptoms of cracking on the surface,
it is imperative to change the petrol tube.
DANGER
Riding with a damaged petrol tube or simply
starting the engine can result in a fire
and consequently an accident (and
corresponding injuries)
50
ALWAYS USE THE ORIGINAL PETROL
TUBE, YOUR OFFICIAL RIEJU SERVICE
CENTRE WILL PROVIDE YOU WITH ONE.