Initial Operation - Bosch BDU280P Owner's Manual

English–11
EN-36
Inserting a PowerTube battery
6
5
2
In order for the battery pack to be inserted, the key 5 must
be inserted into the lock 6 and the lock must be unlocked.
 To insert the PowerTube battery, 15 place it so that its
contacts are in the lower bracket of the frame.
 Push the battery upwards until it is held by the safety
restraint 14.
 Press the battery upwards until you hear it engage.
Check that the battery is secure.
 Always secure the battery by closing the lock 6 – other-
wise, the lock may open and the battery may fall out of
the bracket.
 Always check that the battery pack is locked in
place. To do this, pull on the battery pack (after the key
has been removed).
After locking, always remove the key 5 from the lock 6. This
prevents the key from falling out and the battery pack from
being removed by unauthorized persons when the eBike is
parked.
0 275 U07 XPX | (8.2.18)
1
4
3
15
Operation

Initial Operation

 Use only original Bosch battery packs approved for
your eBike by the manufacturer and purchased from
a trusted source. Use of non-approved or counterfeit
battery packs can lead to death or serious injury.
Switching On and Off
14
Switching the battery pack on is one of the ways of starting
the eBike system. Read and follow the operating instruc-
tions for the drive unit and the on-board computer.
Before switching on the battery pack or the eBike system,
check that the lock 6 is locked.
To switch on the battery pack, press the On/Off button 4.
The LEDs for indicator 3 light up and, at the same time, indi-
cate the charge condition.
 Always check that the battery pack is locked in
place. To do this, pull on the battery pack (after the key
has been removed).
Note: When the battery pack capacity is below 5 %, none of
the LEDs for charge-control indicator 3 will light up. Only
the on-board computer will indicate if the eBike system is
switched on.
To switch off the battery pack, press the On/Off button 4
again. The LEDs for indicator 3 go out. This also switches
off the eBike system.
When no power output from the eBike drive unit is request-
ed for approx. 10 minutes (e.g., because the eBike is
parked) and no button for the drive on-board computer or
operating unit is pressed, then the eBike system, and thus
the battery pack, automatically switches off to save energy.
The battery pack is protected against deep discharging,
overcharging, overheating and short-circuiting by the
"Electronic Cell Protection (ECP)". In case of hazardous sit-
uations, a protective circuit automatically switches off the
battery pack.
When a defect in the battery pack is
detected, two LEDs for the charge-
control indicator 3 flash. In this case,
please contact an authorized Bosch
eBike dealer.
Bosch eBike Systems