Checking The Brake Oil Level - Gilera Runner 125VX Manual

Table of Contents

Advertisement

CAUTION
IF THE FIRST AND THE LAST SEGMENTS OF THE COOLANT LEVEL INDICA-
TOR FLASH, CONTACT AN AUTHORISED PIAGGIO SERVICE CENTRE TO
CHECK THE INDICATOR.
IF THE FIRST AND THE LAST SEGMENTS OF THE COOLANT LEVEL TEMPER-
ATURE INDICATOR FLASH WHEN RIDING IN EXTREMELY LOW TEMPERA-
TURE CONDITIONS -TEMPERATURE BELOW 15º C - JUST SWITCH OFF THE
ENGINE AND WAIT FOR ONE MINUTE; THE FLASHING WILL AUTOMATICALLY
STOP. IF THE SEGMENTS KEEP FLASHING, CONTACT AN AUTHORISED PIAG-
GIO SERVICE CENTRE.
Recommended products
SPECIAL AGIP PERMANENT
coolant
Monoethylene glycol-based antifreeze fluid, CUNA NC 956-16

Checking the brake oil level (03_17, 03_18)

The brake fluid reservoirs are fitted with a transparent indicator "A"; the amount of
brake fluid seen through the transparent indicator shows the level of fluid contained
in the reservoir.
When the indicator "A" is full, the level inside the reservoir exceeds the MIN level;
when it is partially full, the level has dropped to the MIN level; when it is completely
empty, the level of fluid in the reservoir is below the MIN level.
The brake fluid level may fall due to wear on the brake pads. Should the level appear
to be below the minimum mark, please contact your nearest PIAGGIO-GILERA Deal-
03_17
er or Authorised Service Centre in order to carry out a thorough inspection of the
braking system. If you need to top up the level, follow the steps listed below. Remove
the front handlebar cover; loosen the 2 screws "B" and lift the brake fluid tank cover
"C". Then, top up with fluid as necessary, (the fluid level must always exceed the
minimum level mark). Place the handlebar in the riding position and pay attention not
44

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Runner 200vxr

Table of Contents