Table of Contents
Advertisement
Ethernet Port
The Ethernet port is used to connect computers to the Modem via Ethernet
cable. The Ethernet port is a
through or crossover Ethernet cable can be used when connecting to the port.
☞
Note: Use a crossover Ethernet cable to connect the Modem
only if connecting to a hub/switch that lacks an uplink port.
Reset Switch
Depressing the Reset switch restores the Modem's factory default settings. To
reset the Modem, depress and hold the Reset switch until the Power light chang-
es from green to orange. When the Power light glows orange, release the Reset
switch (this may take from 4 to 7 seconds). The reset process starts after releasing
the switch.
Power Port
The Power port is used to connect the Power cord to the Modem.
N
Warning: Do not unplug the Power cord from the Modem dur-
ing the reset process. Doing so may result in permanent damage
to the Modem.
Power Switch
The Power switch is used to power the Modem on and off.
Chapter 1 Introduction
Mbps auto-sensing port, and either a straight-
10/100
5
Advertisement
Table of Contents
