Battery Pack And Charger - LawnMaster NPTGCP2617A Operator's Manual

ASSEMBLY
ADJUSTING THE ASSIST HANDLE
Never adjust the assist handle while the trimmer head is running. Failure to stop the engine may
cause serious personal injury.
The assist handle is pre-installed at delivery. Inspect and adjust it before operation if necessary.
■ Release the assist handle cam lock.
■ Adjust the assist handle using the anti-vibration ball to your most comfortable position as shown
(Fig. 9).
■ Secure the assist handle cam lock. Pay attention not to position the assist handle under the
shaft (Fig. 10).
■ The assist handle can only move in the direction indicated by the two arrows in Fig. 9, between
the two arrows marked "Handle Position".

BATTERY PACK AND CHARGER

BATTERY CHARGING
■ Use only with 8.4V LawnMaster
supplied is specifically designed for the lithium-ion battery used in this tool.
■ Check the power voltage! Battery chargers operate on 100-240V AC.
■ Charge the battery between 40°F (4°C) and 100°F (38°C) to ensure an optimum battery service
life.
■ Protect the battery from heat, from continuous exposure to sun, and keep away from radiation
or other heat sources. Do not leave the battery in the tool in direct sunlight over long periods.
■ The battery is supplied uncharged. Fully charge the battery before using the tool for the first
time. The lithium-ion battery can be charged at any time without reducing its service life.
Interrupting the charging procedure does not affect the battery.
(See Figs. 9-10)
Fig. 9
YLS0042-T084045 battery charger. The battery charger
®
14
Fig. 10