KI Trek Quick Manual

February, 2002
KI
1330 Bellevue Street
P.O. Box 8100
Green Bay, Wisconsin 54308-8100
TEL (920) 468-8100
FAX (920) 468-0280
Assembly Instructions
™
Trek & DataLink ® Multipurpose Folding Table
leveling
glide
Figure 1
short-fold
adapter plate
leveling
glide
standard
base
Figure 2
Assemble units as described herein only. To do otherwise may result in instability. All screws, nuts and bolts must be checked periodically
after assembly. Failure to assemble properly, or to secure parts may result in assembly failure and injury. Illustrations and
specifications are based on current product information at the time of this printing.
#14 x 1"
screw
standard
base
table top
#14 x 1"
screw
#14 x 1"
screw
short-fold
base
table top
Tools Required:
• Phillips Screwdriver
Hardware Included:
• (8) #14 x 1" Wood Screws
• (4) Glides
standard
Note: The instructions below
base
illustrate the assembly of both the
lightweight folding base (Figure 1)
and the short-fold base (Figure 2).
The item that is required to make the
base a short-fold base is the
short-fold adapter plate (Figure 2).
It is only on one base of each pair.
The adapter plate allows the folded
leg to be clamped shut while
overlapping the opposite leg.
1. Place the table top upside down onto
a soft protective surface.
2. Locate the four pre-drilled holes at
each end of the table. Align the holes
of each base with the pre-drilled holes
in the table. The folded legs of the
bases must be positioned toward the
center of the table. If installation
requires a short-fold base (Figure 2),
the short-fold leg must be positioned
over the standard leg.
3. Secure the bases to the table with four
#14 x 1" wood screws provided.
4. Screw two leveling glides into the
threads at the bottom of each leg.