Related Manuals for J D Williams New England 4 Drawer Unit QN856
Summary of Contents for J D Williams New England 4 Drawer Unit QN856
- Page 1 New England 4 Drawer Unit Assembly Instructions QN856 - Please keep for future reference Dimensions Width - 19cm Depth - 25cm Height - 65cm Important – Please read these instructions fully before starting assembly...
-
Page 2: Care And Maintenance
Safety and Care Advice Important – Please read these instructions fully before starting assembly • Check you have all the • During assembly do not stand • We do not components and tools listed on or put weight on the product, recommend the use pages 2 and 3.. - Page 3 Components - Panels Please check you have all the panels listed below 19(w)cm x 25(d)cm 23.8(d)cm x 63.8(h)cm 23.8(d)cm x 63.8(h)cm 13.6(w)cm x 6(d)cm 13.6(w)cm x 23.7(d)cm 13.6(w)cm x 23.7(d)cm 13.2(w)cm x 12.5(h)cm 21.7(w)cm x 12.5(h)cm 20.6(w)cm x 12.2(d)cm 11.5(w)cm x 12.5(h)cm...
-
Page 4: Tools Required
Components - Fittings Note: may be supplied than are required. Male Camlock x Female Camlock x Handle x Handle x Protective Feet x 4 Tools required Phillips screwdriver (medium & large) Ruler - Use this ruler to help correctly identify the screws 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170 The screws length is measured from the head to the point (30mm screw shown). - Page 5 Using Camlocks Push the male camlock Connect the male camlock as directed in into the entry hole. the assembly instructions using a screwdriver. Turn the female camlock lnsert the female clockwise with a camlock as shown in the screwdriver. instructions You should feel a click Note: ensure that the when the camlock is...
- Page 6 To assemble the drawers 1. Screw drawer front 10 to 2 x drawer sides 11 using 4 x screw K as shown using a Phillips Screwdriver. 2. Slide drawer bottom 12 along grooves in 2 x panels 11. 3. Connect drawer back 13 to 2 x drawer sides 11 with 4 x screws K using a Phillips Screwdriver...
- Page 7 1. Connect 2 x supports 4 to left side panel by locating them onto 2 x male camlocks. 2. Insert 4 x female camlocks into the under side of supports 4 as shown. Use a screwdriver to turn the female camlock clockwise to lock.
- Page 8 1. Locate top panel 1 onto left side panel 2 and right side panel 3 as shown. 2.Insert 4 x female camlocks into side panels Use a screwdriver to turn the female camlock clockwise to lock. Please refer to the “Using Camlocks”...
- Page 9 Washer x 2 washer and 1 x wall using 1 x washer G and wall screw H...